User Guide
User Guide
Anatomy of the Turboblender
Your First Blend
Make sure your blender is fully charged by checking whether all indicator lights are on before your first blend. Tighten the body and base until the magnet is align with the power button. Press power button twice to start blending and remember to clean it immediately after use.
Step 1
Cut fruits into small pieces before adding into the blender to fill up about 60% of the jar capacity.
Step 2
Add some water until it reaches 80% of jar capacity.
Step 3
Tighten the lid and tilt down the blender to make sure fruit pieces are not stuck under the blades.
Step 4
Press power button twice to start blending.
Normal Use Display
Press power button twice to start, press it once to stop. When idling, press power button once to check battery level.
All indicator lights will be continuously flashing upwards.
Indicator light(s) will be flashing slowly at current battery level.
All indicator lights will be flashing in red while blending.
All indicator lights will light up in blue.
Troubleshooting and Malfunctioning Analysis
| Malfuction | Analysis | Troubleshooting |
|---|---|---|
All indicator lights light up in red, unable to start. |
Ran out of battery |
Charge it for 4 to 5 hours to make sure that it gets a full charge. |
All indicator lights flicker in red and blue alternately, unable to start. |
The jar is not tighten to the base. |
Tighten the jar and base, make sure the magnet is align with the power button. |
Stop working after 4 seconds. |
Blender is empty. |
Add ingredients into blender to start blending. |
Stop working, all indicator lights flicker in red for 5 seconds. |
Ingredient is too thick / overload. |
Add some liquid or cut ingredients into smaller pieces, then restart it. |
Leakage |
The sealing ring is not placed properly. |
Place the sealing ring properly |
DONT's
Nam dictum tincidunt nec dignissim varius mollis pharetra
DO NOT remove the lid or add in something rigid in your blender when it is blending.
DO NOT submerge the base into water to prevent base elements from damaging and make sure it is off before cleaning.
DO NOT disinfect your blender in microwave or hot water above 80°C.
DO NOT clean your blender with any kind of metallic spiral ball to prevent parts from scratching or damaging.
DO NOT repair or disassemble it by yourself otherwise your warranty will be void. If malfunction occurred, kindly contact us.